Indesit washing machine repair
Posted: Mon Feb 17, 2025 4:12 am
The intake hose and filter become clogged with impurities from tap water. Therefore, the parts need to be cleaned regularly. Otherwise, a fault code is displayed on the display.
Let's tell you right away how to deal with simple problems - blockages. If the equipment is blocked, the tank is empty, and the wash does not start, then:
Disconnect the washing machine from the mains.
Disconnect the intake hose and check for blockage. Rinse with warm water.
Use pliers to remove the filter mesh.
Wash it with a brush and a solution of citric acid.
Inspect the fill valve.
If you notice that the device does not take powder from oman telegram data the tray, then it is necessary to clean the parts:
Remove the dispenser.
Wash under warm water.
It is worth cleaning the hoses that supply water from the valve to the hopper.
To clean the drain line, it is better to turn the body on its side to open access to the bottom. Beforehand:
Remove the base panel.
Unscrew the filter counterclockwise.
Place a container underneath and drain the water.
Lay the washing machine on its side. Loosen the clamp of the pump pipe. Remove any debris from it. Also clean the hose. Make sure there is no hair or thread on the impeller.
Now let's move on to serious faults and their elimination.
We start the machine . Burnout of the interference filter or the track on the control board leads to the equipment failure. The main cause of the malfunction is voltage drops in the network. High humidity in the room also affects, as a result of which the elements on the board oxidize.
Start your inspection with the external parts:
The power cord. It must be intact, without damage to the insulation.
Plugs and sockets. If you see burn marks or melted parts, they need to be replaced.
Remove the top cover.
Let's tell you right away how to deal with simple problems - blockages. If the equipment is blocked, the tank is empty, and the wash does not start, then:
Disconnect the washing machine from the mains.
Disconnect the intake hose and check for blockage. Rinse with warm water.
Use pliers to remove the filter mesh.
Wash it with a brush and a solution of citric acid.
Inspect the fill valve.
If you notice that the device does not take powder from oman telegram data the tray, then it is necessary to clean the parts:
Remove the dispenser.
Wash under warm water.
It is worth cleaning the hoses that supply water from the valve to the hopper.
To clean the drain line, it is better to turn the body on its side to open access to the bottom. Beforehand:
Remove the base panel.
Unscrew the filter counterclockwise.
Place a container underneath and drain the water.
Lay the washing machine on its side. Loosen the clamp of the pump pipe. Remove any debris from it. Also clean the hose. Make sure there is no hair or thread on the impeller.
Now let's move on to serious faults and their elimination.
We start the machine . Burnout of the interference filter or the track on the control board leads to the equipment failure. The main cause of the malfunction is voltage drops in the network. High humidity in the room also affects, as a result of which the elements on the board oxidize.
Start your inspection with the external parts:
The power cord. It must be intact, without damage to the insulation.
Plugs and sockets. If you see burn marks or melted parts, they need to be replaced.
Remove the top cover.